Search found 6 matches

by MugenSi99
Tue Nov 07, 2006 8:56 am
Forum: s300 / SManager
Topic: cant get the car to idle
Replies: 4
Views: 4131

yeah I have it all equalized out to 800rpm's at idle... and since it has gotton cold, when i give it gas and let off, the idle goes up and starts surging up and down... any ideas of what this might be? bad Idle air control valve? it worked fine before hondata though....
by MugenSi99
Tue Oct 31, 2006 4:53 pm
Forum: s300 / SManager
Topic: cant get the car to idle
Replies: 4
Views: 4131

I have this same issue with my b16a2.... I havn't found out what it could be....
by MugenSi99
Fri Oct 20, 2006 9:13 pm
Forum: Non-Hondata
Topic: Help! IAT question
Replies: 7
Views: 6491

thanks jaker!! this helped alot... I was confused between people saying it was already on there and stuff... I greatly appreciate your response!! hopefully this thread will help other people out!
by MugenSi99
Thu Oct 19, 2006 9:15 am
Forum: Non-Hondata
Topic: Help! IAT question
Replies: 7
Views: 6491

mabye I'm thinking of the wrong thing :? where does the sensor that is on the intake tube go? this is one of the VERY few if not the last thing I am unsure about...
by MugenSi99
Wed Oct 18, 2006 8:05 pm
Forum: Non-Hondata
Topic: Help! IAT question
Replies: 7
Views: 6491

thanks!! you just helped me out GREATLY!! I wasn't sure if the boost would affect it or not... but I have been reading where iat temps are measured, so I didn't think it went on the turbo inlet tube... Thanks again for the info!
by MugenSi99
Tue Oct 17, 2006 8:46 pm
Forum: Non-Hondata
Topic: Help! IAT question
Replies: 7
Views: 6491

Help! IAT question

hey everyone!! I'm going to be turbo'ing my car soon.... I have hondata s300 installed and everything.. I drive a 99 civic Si with the stock b16a2... well I have a dumb question...

Where does the Intake Air Temp. sensor go when I install the turbo?

does it go to the turbo inlet tube after the ...