Hondata

All sorted,

Well I just spoke to guy I bought it from and it's changed hands a few time with the car, it was last mapped a year ago by jcal, he apparently didn't run it with lambda so I'm wondering if it's my map, I may have to try putting a new calibration on and then enabling wideband

As in a bad soldering install to the board

thank you for the reply please see picture

Hi guys, i have just switched from a hondavert 1.6 to a kpro v4 so i can install a wideband. i uploaded my calibration from my hondavert to the kpro v4 (i know its probably not recomended.

I have used the correct pig tale, as for wiring i have done the following

White wire going into analouge 0 ...

I will look into fitting one thankyou

hi bud, its a 3rd gear run, starting at 2k rpm to near redline, there are 2 runs both sort of the same just one i changed up gear at one point

Hi yes running a stock engine other then bolt on mods. I have loaded a base map on there. Smells a bit lean in higher rpm, no smoke though in vtec or across rev range apart from a little puff here and there. Also smells a bit rich on lower rpm but it's decatted so maybe a red herring

hi, i just got a kpro v4, does anyone have a base file for the following mods

skunk 2 style inlet
k&n typhoon
custome 2.75 inch exhaust which was from a previous car that achieved 242 on dyno
421 toyosports manifold

just learning at the moment and new to honda world, i would get it rolling road ...