Hondata

email sent.

resistor type - BKR7EIX

version of kmanager


ecu/hondata ecu info

removed the cover and went for a drive. my samsung phone stayed connected for about 13 minutes and then would not reconnect. these messages come up when i try to reconnect.

i'vel always had bluetooth connections issues since day one with kpro. at first i was just using my phone, a samsung. i then connected an ipad. same intermittent issues. either device always connections, but almost always disconnects during a drive. i can back out of hondata and then reopen and this ...

hello, i am unable to get the vss input to change on the display screen. the vss shows changes in the graph screen and on the sensor screen. the vss input on the sensor screen does not change.is this supposed to show changes on the display screen? i have tried 2 different ecus with the same result ...

Thank you.

Is there a low limit to the shift light rpm?

haven't connected E18 output to the circuit. just testing the output with a meter.

hello, using E18 shift light output to trigger (-) a relay for aftermarket shift light. is there a low limit to the rpm it can be set at? i have 1st gear rpm set to 2000rpm to see if i can get the light to turn on. it the output does not read ground at 2000rpm or above. metering the output of E18 ...

will do. is the vss something that is tested when an ecu is sent to hondata for the upgrade?

after doing some research it appears the speed sensor on this transmission is outputting the same signal as a speed sensor on a 2002-2004 rsx. 3-wire 12 volt sensor with 4000 pulses per mile. can you hypothesis why the kpro is not reading the input? could the ecu be the issue?

I have not. Figured I would post here 1st incase it was just a setting. The speed sensor is 12 volt input. Can I use the alternate vss with this sensor, or does it need to be a 5 volt?

hello, doing a kswap on a 1992 toyota mr2. using the original transmission to the vehicle. it is a E153 manual transmission with what i believe is a hall effect style speed sensor. speed sensor is confirmed to be outputting. the vehicles factory speedometer reads and an oscope (see photo) is also ...

correct. the setting always defaults to on regardless of what setting i choose or if its inverted or not. it seems like your not getting what i'm trying to explain. i must not be stating my issue properly. i apologize.