Hondata

thanks @spunkster @kraquepype
you're right i need to re-check my wideband wiring to sort that voltage offset. And i think i resolved the leaning out issue.
Iit seemed that my closed loop (wideband voltage) was what was causing this issue. I re-started a fresh calibration and after tuning open ...

It's my first Hondata experience and still learning, appreciate any support

So I've tuned the car on open loop for low fuel maps, car runs fine.
I switched to close loop and began to tune my high fuel map. On 4th gear if i go WOT at around 4500 and before the vtec switchover point (vtec is at 5200 ...

Thank you!
Issue resolved. Yes kept trying on my Macbook running VMware Fusion. Used a USB 2.0 hub kept playing around with the drivers, re-installed and all green ticks. Car is out of limp mode and ready to tune

These are the steps I tried, something worked out of it.

My drivers showed updated and showed no issues. I was trying through a USB hub 2.0 but nothing worked.

1. I re downloaded the drivers from the Hondata site. Let it uninstall and reinstall
2. I went to device manager and in hardware changes I ...

Issue resolved. Yes kept trying on my Macbook running VMware Fusion. Used a USB 2.0 hub kept playing around with the drivers, re-installed and all green ticks. Car is out of limp mode and ready to tune 😃

Hi I'm having trouble running Smanager on VM Fusion on my Macbook. Any advice? ECU went to limp mode and it's not communicating with the ECU

I tried this on Windows and didn't seem to resolve the problem. Using a USB 2.0 hub also didnt seem to work. Anything else I can try?

I'm having the same issue. But cannot seem to resolve even though I'm connected to the internet?

Hi all
Just got my hands on a Civic Eg with a B16b running a Hondata S300 V3.

Plugged it into my laptop yesterday to take a copy of the map on the ECU and start logging to create a new calibration. As soon as I plugged in, it said s300 needs to update firmware and appeared to be frozen for more ...