Hondata

Alright… anyone have any suggestions for the no start?

I see in the datalog where it blips on for a second and turns back off if thats what you are refering to. Is there something that could be causing this? Maybe some sort of software issue?

Okay do you think this could be the cause of a no start condition? I checked the 'Secondary Tables' under parameters and it says disabled. What would cause it to be used during the datalog when it's not even turned on in the setting?

thank you for that info! i’m somewhat glad to hear i’m not the only one who is struggling with this issue. It’d be nice if they had that setting but i’m sure they’re more worried about developing new features for the new vehicles /: i honestly debating switching to smaller injectors and retune ...

I’m honestly not sure i had it dyno tuned by a reputable tuner and have been trying to adjust the in town tuning myself. I haven’t personally changed that setting before. is there a way to check if it was tuned on the secondary tables?

Okay i just checked that so that’s on now on the calibration. Was that something that may have been the issue or do i need to post a new calibration file showing that?

My car keeps getting not starting back up and just cranks and cranks. The only way it eventually starts is to let it sit and keep trying every few minutes. After 3-7 trys it will eventually start. Usually happens after driving then shutting off for 3 minutes, sometimes even happens after 30 minutes ...

Did you ever find a fix for this? i’m running into the same issue and cannot seem to get enough fuel after hot restarts. Sure i can run closed loop but it still barely starts and runs rough for 30 seconds if IAT is over 130

Tried ecu in known good vehicle and problem persists. Leads me to believe it’s the ecu or s300 is there anyway to check which one it is without cutting any jumpers

Yeah all capacitors replaced about a year ago when the board was installed and j12 removed. For reference it was fully running, data logging, tuned before I parked it for 2 months

Serial number is 54391 and version 2.8.1.0
Pics of soldering

Looking for some advice. When ignition is switched on, fuel pump does not prime. I figured I would hook up the computer just to see if i seen anything out of the ordinary. However when starting datalogging, nothing will read on any sensors and ECT and IAT will display 320 degrees or so. Green light ...