Hondata

Also:
- Latest version of SManager
- ECU - P06
- F20B
- Rywire H/F harness
- Denso S2000 Coils

Recently I’ve been getting an intermittent sync light on the CPR when trying to start the car.
1) I’ve followed the troubleshooting guide here https://www.hondata.com/help/cpr/index.html?troubleshooting.htm and completed all the steps.
2) I’ve never had this issue before with all of the exact same ...

This shit is comical. Switch CAN H/L wires and no SYNC light again.

Really odd, when I had the CAN output set to the Hondata Protocol 500kbps option, I was getting no Sync light in the CPR. Switched it to the MOTEC SDL, uploaded the config to the S300, boom new engine starts right up. No data populating on my AEM; but, the big problem is solved.

Swapping CAN wires ...

Thanks Spunkster. My SManager shows a "Hondata Protocol 500kbps"

I switched it over to the Motec and will be trying to swap the H and L CAN lines.

I need to diagnose why I'm not getting a SYNC light right now. Worked before I took the head off, now nothing. Ran through all of the troubleshooting ...

Also the latest versions of AEM software are being used and latest version of Hondata

I have the AEM CD7 setup to receive CAN inputs over Port 2 on the CD7 with a 500kbps baud rate.
In SManager do I select the Motec SDL/ADL or the Hondata 500kbps output?
I've tried following the AEM write-up and I still can't get data to populate on the AEM. There is output voltage coming out of the ...