Hondata

Can it be run or not ? Because it says PCS outputs cannot be used.

Can you post ur new tune without the leaking flex pipe?

yes i would like to have them also

Ok it says to run the gray wire from the PLX to the white wire on your old o2 harness. My problem is there are two white wires and dont know which one I need to use. This is a 98 Prelude SH.

Ok i got it to work. But the idle is jumpy and the car stalled within 5 mins of it running and wouldnt start again

SManager V1.1.5

that file wouldnt open correctly on my computer

There will be a meet behind the boscovs at the exton mall which is off of route 100...... It will start at 8.. Everyone is welcome.



http://www.mapquest.com/maps/map.adp?searchtype=address&country=US&addtohistory=&searchtab=home&formtype=address&popflag=0&latitude=&longitude=&name=&phone=&level ...

Need a map for h22 running just bolt ons

ok it worked good. But now the car bogs terrible at around 4k and wont rev any higher. The rev limit is set at 7400

I just installed my ecu im having a few problems. I installed a obd1 jdm p72 ecu with hondata s300j. In anyother post i described the one problem but I also have another one. I am also getting an ATTS light and also a check engine light. Under the kickplate where the ecu sits on the SH prelude there ...

Im his friend that hes talking about. How do i disable the code ? If its giving me a code doesnt that mean that there is a problem ? I have the injector setting: stock 290 and current 290. This is on a 98 prelude sh.