Hondata

So, the issue is now gone and I don't really know what happened. I will be getting an Acuity TPS just in case mine would fail. I got some replies on the k20a.org forums so I'll leave the link for information purpose: https://www.k20a.org/threads/bogging-an ... id=3360223

Hello,

Vehicle:
- Civic EG
- K24A3 / K20A2 frank
- ECU : 37820-PRA-E02
- K-Pro V4

Issues:
- TPS reads 3% - 97% when engine is off, -2% - 60% when engine on.
- Revving while at a stop, the injectors cut out every other second.
- When moving on slight throttle, the injectors will cut out every few ...

Very well, thank you very much ! I'll follow your advice.

Forgot to mention : this is with some electrical load (headlights on). With no load, the engine stays at around 850rpm, but that's still way under my target of 1000rpm.

Thanks

Hi,

I have a K20A2 with a PRA ECU and IACV delete (I got the car like this).

Recently I discovered an air leak at the intake, I fixed it but now I need to redo the calibration as it is too rich.

I got my idle at 14.70 but the engine bounces between 650-800rpm which is too low.

The easy solution ...

I picked up a USB C to USB B cable today and followed your instructions, and it now seems to be working properly. Thanks a lot !

Hello,

I recently got a new DELL XPS 15 laptop which has only got USB Type C ports, so I connect via a USB hub. Unfortunately whenever I connect to the ECU it will show up values for a second or two and crash without any error message (KManager exits completely). I did not have this issue with my ...

Hi Ed,

Thank you for your input, it's really appreciated and reassuring.

The previous owner sold the car before the tune was finished for unrelated reasons (or at least so I was told).

I guess it's best I check with a det can just for peace of mind. I'll update this post if there's anything new.

Hello,

I'm very new to tuning but have been following courses intensively for the past few weeks and finally jumped into Kpro. I'm looking for some advice about my current logs.

I bought my EG with the following setup:
- K20A2 (PRA)
- Drag Cartel 2.2 cams
- Bosch 550cc EV14 injectors
- ACL ...