Hondata

OEM AP1 flywheel (14lbs).
Didn't want too light so as to keep street drivability. Rotating mass of the motor now seems lighter though so I'm sure that contributes.

It has not, I haven't been able to make time with my tuner, just wanted to get it running as close to "safe" as I could before going, as when I first was running the built motor the tune was extremely lean. So just working on getting it running well-enough, I haven't touched timing really and was ...

Sleeved block with Inline Pro F24 pistons/rods kit for 10:1 compression
Inline Pro Stage 2.5 Head
ID1000cc injectors
Walbro 450lph wired to battery, converted to return-style fuel system with -6an feed, stock feed used as return line.
Injen Intake and DC Sports header, currently running non-catted ...

Hello,
My car is having an intermittent issue with shutting off at idle randomly, and moreso when there is more load on the engine (AC).
I first experienced the issue when ambient temps here in southern California began to rise, and with the car on pump gas and dialing the dead times (ID1000), which ...

Yes, factory pin removed and new pin coming from output of the converter wired in to ECT2, with ECT2 disabled in Flashpro.
After calling Ktuner, determined that the converter is not receiving a signal from the Flex Fuel sensor, and when that happens it shows a constant voltage that shows as 100 ...

I went over all the wiring, all grounds are good, and I felt as though my wiring into ECT2 was not the best so I repinned it better, and now instead of 0 ethanol when running it is now detecting 100% ethanol (which I know for a fact is not the amount in the tank). I will attach a datalog.
Other ...

Forgot to add, I attempted to try connecting power to the 12V Constant as pointed to in the attached picture, and a datalog showed ethanol alternating between 0-1% with no consistency.

I haven’t been able to confirm with a multimeter, but it is wired into the 12V switched source under the dash, I will attach a picture of where it is wired to and the power panel used is this: https://www.scienceofspeed.com/index.php/s2000/enpp/engine-sensors-gauges-accessories/scienceofspeed ...

Should also add, does not detect when key turned to Ignition at all, only when actually cranking.

Hello,
I recently wired in my flex fuel sensor, digital-to-analog adapter, and Science of Speed accessory power panel, and enabled it all correctly in Flashpro, but it is only detecting ethanol percentage when cranking, and at any other time it just reads 0%. When cranking its currently reading ...