Hondata

Ok, I know they have the Kpro for the Element, and I want to run a turbo in the Element.

Ok, BUT I am doing the Frankenstien conversion to the K24. If you don't know what frank is check this link.

http://forums.clubrsx.com/showthread.php?t=392509&highlight=Frankenstien

Anyway, I am going to run ...

Are you sure that the sensors you have that you say are good are the right kidn of sensor? What is the part number on these sensors?

Same as stock, I purchased them both from the dealer. 02 Acura RSX Type S they both have the same part number. I don't have it with me at the moment or I could give ...

Why did the heaters fail? Do they work now? The o2 sensor will not work if the heaters do not.

Well no they have been working I had a code about the preheaters way back when and the 02 has worked fine. The secondary is fully fuctional and I can read the voltage in Kpro. Primary worked fine until ...

What do you mean 'they died when I gutted the cat?' If the o2 sensors fail back then the question would then be why did they fail, and has the original problem been fixed?

The O2 sensor did not fail but the preheaters died after I gutted the cat.

The 02 sensor stopped working after I loaded the ...

Hondata wrote:Clear security and re-upload the calibration.

I will try this.

Hondata wrote:The most common cause of P1166 is excessive exhaust vibration damaging the o2 sensor, followed by incorrect wiring burning out the ECU o2 heater drive circuit.

They died when I gutted my cat back in 02.

I am getting the Code 41-1 DTC P1166 Kpro. It was working just fine then I changed a calibration and it stopped working. Since I never drive my car and I have had Kpro for less than 2000 miles. I would think there is nothing wrong with the ECU. No changes have been made to the electrical system only ...

I too am having them problem with the o2 sensor.

Code 41-1 DTC P1166 Kpro

--------------------------------------------------------------------------------

Ok, I have a very weird problem. My primary o2 is getting the following code. I have run the diags in the book shreaded my car looking and ...