Hondata

What would be the best thing to monitor to adjust throttle opening from low to mid rpm when the pedal is instantly floored from a stop. I’m trying to get a more efficient low end power without easing into pedal before flooring it. Playing with air flow velocity for better transition I’m not really ...

Are there any tables or settings that set throttle plate position based off of MAP and RPM instead of only peddle position or
change it in other ways in flashpro?
I smoothed the base map table for Target Throttle Plate
a little and had to retarded some timing at 3,000 down in my column 8.
I ...

Are there any tables or settings that set throttle plate position based off of MAP and RPM instead of only peddle position or
change it in other ways in flashpro?

I smoothed the base map table for Target Throttle Plate
a little and had to retarded some timing at 3,000 down in my column 8.
I ...

Thank you.

I read the warning about vtec point not being set
Below 2000 rpm or oil pressure will drop but I noticed that base maps start at 1100 , is that right for the R18 or should it all be changed 2000 and up?

Is there any way in advance xy graph for values to be shown 0.00 hundreds for voltage or is it only available to be viewed in 0.0 tenths on these graphs?

This would be helpful for fine tuning MAF scaling. If there is a way already, I would appreciate it if someone could help me. I haven't been ...

Is there any way in advance xy graph for values to be shown 0.00 hundreds for voltage or is it only available to be viewed in 0.0 tenths on these graphs?