Hondata

Has never worked properly since I bought it used this year.

Starter went out*

It’s allowing me to load the base calibration. I forgot to turn the key on.

But sensor values are still wrong. Shows VSS is going 52mph but car is parked.

Thanks.

Stater went out.

Now it’s shows failure to load calibration.

It shows the old base RSX factory calibration was loaded in “calibration storage.”

It’ll run but runs very bad.

Sensor window still shows all the incorrect values. RPM says I’m going 5400 and it’s not even running.

Thanks.

Yes it will allow it.

The RPM is stuck on 5k
VSS stuck at 52 mph
MAP reads 302.1 psi
TPS 30%
CAM 20
Duty 100%
CLV 33%

All show the same incorrect data that never changes, no matter If the car is running or not.

Basically showing all the wrong info on the sensors display. And won’t show the actual data the car puts out ...

Ahh I see, so what can I do to have it show the correct data? It will run just fine showing the wrong info.

The yellow lightning bolt, as soon click on it all the data from the last tune will auto fill.

I did try a few times to no avail. Went ahead and attempted again this morning.

Each time a calibration is attempted it still shows the old map engine data. RPM/MAP/TPS.

Was able to load another tune from another Kpro, save it and then load it to this kpro. Runs fine but still shows the other ...

- 02 RSX base
- 42035
- version 4 5 1 0
- ECU part number (starts with 37820 PRB A07 2068-704354)
- 4 5 1 0
- the calibration (as an attachment)?
- a datalog of a problem, not working.
- only a cold air intake.
- yesterday from a guy in Killeen Texas. Used. Luis Colon.
- issue is the display and ...