Hondata

Did you disable the engine oil level in the misc. section of the calibration window before uploading to the ECU?


Yes i did. i tried different calibrations. started using only flashpro group n folder (oil level sensor reading allowed) but still died out after a while and did not start again. I ...

I installed flashpro and removed the oil level sensor but it didn't help. the car, meanwhile, starts and runs beautifully in about twenty seconds. I checked the plug on the oil level sensor, there was no + number on terminal 3 , I tried direct current, the error code p250a disappeared with direct ...

Hello, the following problem in the fn2 type-r car p250a fault (oil level sensor). I have replaced the sensor, checked the oil level, the cables are ok and the ecu software has been updated at the honda service. The car starts and dies after a few moments and sometimes does not start. Ecu receives ...