Hondata

that looks very clean very nice

And i don,t got any power steering on my car..

ok so its normal that i cant use them?because they are always activated..

well,in my sensor list my psp and vtp are always on and i cant get them off,no matter what i do, so i cant use them .
Can i solve this issue some way??

thanks in advance

hey guys ,besides that open loop function is not working, my psp and vtp are always on, is that normal?

Ok i gonna try that to,im converting my crx to all wheel drive at the moment so its gonna wait till im finished with the awd

ok so you say it is normal that i can only tune in closed loop and that the af ratio in open loop from 8.50 to 18.00 go up and down in 2 seconds and with a lot of throttle can just keep running, and whatever I do in the tables has no effect at all and in closed loop with st and lt on 0 the tuning ...

i know that the car should not act like this in openloop,in openloop ican change the fuel table but nothing changes as it should be and in closed loop with trims at 0 it works as it should be .i found more people with this problem only not a solution,but i tune in closed loop then it works but i ...

I also got this problem ,i can tune in closed loop and it works fine,only after i did a pull and stop for traffic lights than idle fluctuates for a 60 sec orso and sometimes stalls and when i try to restart the car it wont run until i wait a few minutes then it runs perfect again and that is very ...

i found a way to tune in closed loop,in closed loop it works when i put the short and long terms set to 0 ,but its not as it shoud be so is there a reasen that it acts like this in open loop?is it the ecu or the hondata?

yes i have the right death times they came with the injectors ,no the car is not being on the dyno yet because i want that everything works as it should be,and if i came by the dyno i know that it will be for nothing because the car is not realy tuneable and my previous p28 did the afr at 14.7 .the ...

- serial number of the s300 inside the ECU
57724
- version of software being used (Help, About)
2.7.8.0
- the calibration (as an attachment)
na heenweg netto.aagep.1.skl
- a datalog of a problem (as an attachment)
Datalog-220314-002.s3d
- what sort of vehicle you have
crx vtec ee8 obdo to ...

Hey guys my build crx runs verry rich when it idle.s above idle it act normal ,i recently had a problem so i baught another p28 and installed the s300 v3 ,but before with the old p28 it idle.d normal .
Dpes anyone know how i can solve this?..

Hey guys,i found the problem, i had all my gauges hooked up to the front off my dash fusebox,there are 3 conection points just above the fuses and i putted more gauges sinds my build and that seems to be the problem because the car runs very nice sinds i removevd that cabel...

ok ill try that,thanks for your advice