Hondata

New calibration and data attached. I also set the min cam angle to -30.

Flex Fuel Street Drive Final.kal 93 Octane Final Run.kdl

It still doesn’t pop up when selected the first time. My current work around is to switch between display lambda values, Display fuel adjustment values sensor overlay ...

Spunkster wrote: Fri Aug 09, 2024 10:55 am Change the number of samples to 1 and it will display

Even when I adjust the sample to 1 it will not display. I'll upload a video

I still have to adjust the transition delay lower (.01) than adjust the acutal amount (1) for it to display.

Spunkster wrote: Fri Aug 09, 2024 9:24 am What wideband are you using?

Can you post the calibration and datalog showing the issue?

This a AEM Wideband 30-0300.
Calibration and datalog attached for your review.

In a k series file I select the lambda overlay selection and it populates and I don’t have to make any changes

This is a PRB ecu in a 05 s2000 with an f series engine

Did not have the same problem when trying this is k series.

Solution

This is my lambda overlay setting untouched I than change it to .01 It shows the overlay numbers and percentages

Don’t want it showing .01. So I got back in and change it to 1 which is a good transition delay

Hondata wrote: Fri Aug 09, 2024 7:28 am Can you describe the behavior so we can look at this?

So here I have kmanager open 4.6.1 I open I calibration I open a datalog Plot somewhere in the datalog I select overlay The overlay is not showing.

I see a lot of talk about lambda overlay not working and the plotting but not showing value. The attached is what I got to work for me.

https://streamable.com/2j79bq

Value don’t show up. Make the sampling rate really low. .01 it should populate values. Than go back in and set it to your like 1 or ...

Here is the explanation I received from a well respected tuner with a lot knowledge.

You won’t be able to do a low / high boost and flex fuel together. The flex fuel boost logic works based on a 0-100% scale. 0% in the flex fuel boost compensation uses 100% of the low boost by gear table. 100% in ...

I reached my post edit limits

My understanding of the hierarchy.
1. When running 93, on low boost setting. Boost will target 0
2. When running 93, on high boost setting. Boost will target whatever value in the high boost table 21-26 in gears 1-4.
3. When running e85, on low boost setting. Boost ...

I'm not a tuner but a car owner and basic knowledge of Kpro for my 05 s2000. I'm planning to have my car retuned, I have moved to a different climate area.

What I am looking to do is run 93 & e85 being able to use low and high boost tables/switch.

Using the attached pictures to explain.

My ...

Is this correct?

Is this correct?

If I make the selection in KManager of "E16 Power steering pressure switch (GND=off)"

The corresponding PIN for a s2000 would be A26. Think I got that now.

One pole off the switch should be stripped back and soldered and into A26. The other pole off the switch should be grounded.