Hondata

Will a haltech ic-7 dash work in a s300? I’m pretty new to the concept of a digital dash but have a lead on one for cheap

Thanks ! How do they wire up? Do I just run one wire to an analog positive pin I choose? They don’t need to be connected to a voltage source?

Are there any pressure sensors I can wire directly into s300? I want to monitor fuel pressure and exhaust back pressure. I currently use an aem pressure guage for oil pressure which uses a 0-5v I can connect to the analog inputs. My questions is, am I going to have to buy a new guage kit for every ...

How does the invert input and output thing work anyway ? If I invert the output does that mean it’s sending out a 12v signal instead if it’s normally a ground?

I did that, made no difference if I check “invert output” it will stay on but I have no control over it, it’s stuck on. This is annoying as hell

calibration and datalog are below. in this log it shows me turning the switch on and off but the ac clutch is not coming on. the only times that it does come on is when i use the test output feature, switches on and off no problem then!

I’ve got my ac clutch output wired to a solenoid (on the ground side) when I test the output of the ac clutch the solenoid activates like it should. I can’t get it to activate through nitrous controls though. I have a switch wired to b5 ac switch, I can see in the sensor bar that my switch is ...

Battery is trunk located and ground is one of those same cables grounded to the body. Where is the fuse. Normally grounded ?

There’s enough to ground a lightning bolt

Also some of the examples I see are no where near vtec activation

I grounded the crap out of the engine in three different spots. It still only does this when pwm is activated.

i was on the dyno today tuning my car and and i finally got to turning my boost controller on and it seems like everytime i did, it would casue some weird ignition cut. ive never run into this before but it put the brakes on the day for sure. can someone please help me see what wrong here ...

I also got a rywire engine harness. Where do I check the tps voltage to make sure it’s getting the right voltage

How do I check voltage at the ecu?

Yes it does