Hondata

Yes it is throwing two check engine codes, one is code 10 and the other is code 21. I’m trying to figure them out now as well. I believe the 21 may be cause the vtec pressure switch isn’t wired up or grounded but I’m not sure. As for the injectors that was a mess up on my part, I was going to ...

Also no wideband at this time and only stock map sensor. I am thinking I need to change both to get it properly tuned, so I am shopping for them now.

This is my fourth start datalog and this is the basemap I'm using.

b16a bottom end
type R pistons
gsr head and cams
arp head studs
oem head gasket
ngk plugs
Blox intake manifold
68mm throttle body
p28 ecu
resistor box for low impedance injectors
oem pressure regulator
1320 4-1 rmf header w/2.5" exhaust
oem map sensor 1 bar
stock injectors

I started the motor ...