Hondata

Ok I’ll post when I get home later tonight.

1st thanks for the help. Ok so I have 2 k pros v4 one is a pnd the other is a prb. I bought the prb to get rid of the pnd. So I downloaded the tune from my pnd to my prb, now when I drive with the prb my engine is breaking up, when I put the pnd back on the engine runs fine. Any suggestions?

thanks for all the info its working now!!

awesome so i need a aftermarket converter thanks. now to get my k pro to read my speed sensor, i need to put the pin on the k-pro board right?

The automatic ECU has no control over the cluster as there is no VSS output from the ECU. The cluster is directly controlled by the signal from the vss.


thanks for the reply so since in getting the p0500 code and its an automatic ecu. should i switch connector A pin 18 to the digital side of ...

Its a V4 k pro

looking to see if my ecu is from a auto rsx? 37820-PND-A55. my swap is in a 99 ek, If it is an auto ecu is there a reason why my cluster is now reading 7mph less then what its actually going? never did this before the swap was b series before.
also i wanted to know if i could do the following to it ...