Hondata

I tried Return to Stock again. When I restarted the car again, it showed the same error messages one by one but then stopped on System Initializing. I understand this happens after the battery is dead and then recharged or replaced and takes a few minutes to clear. I drove around the block and the ...

I recharged the battery. I was able to connect to the OBDII and ECU. I reran Return to Stock but I still get the errors after I start the engine. I just sent a second feedback report for your review. Thanks.

OK, feedback has been sent. Thanks for your help.

The ignition will not turn on. The start button just flashes slowly. nothing happens when you press it. Will unhooking the battery car battery terminal reset everything?

The firmware has updated, but I still have red X on OBDII and ECU. Pressing the start button does not advance to ignition like normal.

The OBDII also has a red X

OK, I have to new version, but I can't connect to the ECU. It has a red X. Pressing the start button does not move to ignition mode. It just blinks.

I have used Flashpro for the past two years without problems. I am now selling the car, so I ran to Return to Stock from the menu. It seemed to load OK. I got the message to "turn off ignition" When I started the engine I was getting all of the system failure messages, but the engine started. I ran ...