Hondata

Hi,

Thanks again for your response.

Am in Czech Republic so we have only 2-3 month summer which mean we can touch the 30. What I remembered is that when I tuned my car it was around 7-10 deg celcius (around IAT 32-34 and ECT - 88) if am not wrong and now it around the 20 so I think that might ...

Hi,

I really appreciate your help. I didn't have time yet to drive my car again. In the meantime I have another question, when I tuned it there was knock free.. it's the first time after tuned I drove for 2 hours + and I saw this.

I tuned my car when in spring that meant he weather temp was quiet ...

Thanks for your reply, I will try this and hope it works, however do you think this can cause any severe harm to the engine. Basically if you have notice it's happening on the cylinder 3 most of the time. I have check my coil, change new spark plug but I can see this repeating. What if I add some ...

Hi guys,

I need some advice here. Am running a stock FN2 with mods only Tss intake. I have street tune my car and everything was perfect since yesterday,

I noticed some knock occurring under 3000-3500 rpm between column 7,8 & 9. I try to pull out 1 degree timing off in the specific cells but the ...

Thanks for your answer. I decrease by three degrees all the cells where the knock was detected.. Will give it a run and thanks for your assistance.

Regards
Abdel

Hi,

Thanks for your response I will try to do this and see. That's mean basically on the low ignition table only on the cell where the knocks kick in or I should remove from the whole table 2 degrees.

Also I can see on the VTC timing table the maximum is 30.. It should be greater as for the cam to ...

Hi Members,

I am new to this world, so I have basically upload the FP base map on my fn2. I have only a TSS intake as mod. The problem is I can see knock only on the 3rd cylinder and would like some advise or help how to go on the FPM and get this solved. I have attached the calibration and two ...

Issue solved..

Hi,
I purchased an accident Fn2 which has a flashpro. I want to know if I can use the ecu on my current running Fn2 to unlock it from the accidented one? Any help would be appreciated.
Regards