Hondata

I am cleaning up the fuel so it might run a little sluggish for now. Load the new tune and create another normal driving log. Try to get higher in the RPM with out going WOT.

-Ed


It feels more sluggish. Died on the road couple of times when clutch was pressed in. Runs 17sh AFR. Heres what I ...

I am cleaning up the fuel so it might run a little sluggish for now. Load the new tune and create another normal driving log. Try to get higher in the RPM with out going WOT.

-Ed


It feels more sluggish. Died on the road couple of times when clutch was pressed in. Runs 17sh AFR. Heres what I ...

I tried it out just now. I had to adjust the IAC to get it up for the first time. Initially it wouldnt continue to run once I started it. Then I removed the FPR vacuum line then started again and it idled fine. After idle is fine I plugged the vacuum hose back in and went for a drive.

After ...

I tried it out just now. I had to adjust the IAC to get it up for the first time. Initially it wouldnt continue to run once I started it. Then I removed the FPR vacuum line then started again and it idled fine. After idle is fine I plugged the vacuum hose back in and went for a drive.

After ...

CalibratEd wrote: Wed Jun 30, 2021 7:43 pm Load the tune and datalog the car normal driving. I smoothed out the map to have a base to work with.

-Ed

Cool thanks! Alright let me try it out. Should I stop-n-go traffic? WOT perhaps?

CalibratEd wrote: Tue Jun 29, 2021 8:48 pm What input do you have your wideband connected to? Did you sync the timing? Does your wideband gauge match the reading in Hondata?

-Ed

Here's the current map and datalog file (most recent)

Oh yes forgot to mention I synced the timing too.

I’ve connected via the O2 D14. Wideband hooked up all good and numbers matches hondata to the wideband.

Finally got it on the road and fixed the leak.

- Wideband installed and used 2001 ITR map.
- was tipped off to use 310cc as stock injector size

Heres some normal street driving. Let me know if you need more pulls. I can try to do it tonight. Thank you in advance!

Unfortunately there’s a minor vacuum leak I gotta fix first (wrong TB gasket).

As soon as I get that all fixed I can do some street pulls. I’m using AEM Uego 30-4110 with Bosch sensor for wideband.

Would you like me to provide you anything from the wideband or Hondata to get started?

Around the same ballpark what I estimated. By the way Ed, hooked up wideband.

I’m currently using a stock b17a map from my previous motor to crank it up.

CalibratEd wrote: Tue Jun 01, 2021 10:48 am I can help tune the car. Do you have a wideband?

-Ed

Yes! Wideband hookup on the way. I’m dropping in this motor as soon as I can and will hookup wideband.

Question, do you have a feel of what HP you think this setup will produce?

Hello Hondata family,

This is my first post and quite new to tuning. Can somebody help me with an initial basemap for my new build? Any tips and feedback greatly appreciated.

THANK YOU IN ADVANCE!!

- B20Z block 11.3:1 CR
- RC Engineering 440cc injector
- 84mm cast ITR pistons
- JG port and ...