Hondata

I have this same problem, how did you solve it?


What is the serial number on the s300 board inside the ECU?

From Help, About, what is the version of software you are using?


Why do they ask so much about the serial number of the board, if in the end they are not going to solve anything ...

I already sent that to you by email and it is a kpro sn 11986, they haven't responded to me for almost a week.

What would the shipping address be for?

What should I put in the address? I am from Panama but I have a locker in Miami, do I enter the address of my locker?

I already sent it, they responded to me with the steps to reset password

11986

It is registered with my data and my email, I receive the reset code, I reset the password and when I go to upload my map it asks me for a password again, am I doing something wrong? Do I have to do something to get the kpro to read the password reset?

I have this same problem, how did you solve it?

Hello, I had an issue with my kpro that asked me for a password to upload the map, I was checking my map and my map sensor was having a bad reading, I changed another map sensor and it kept reading me with fluctuations, I decided to delete the map in the delete option ecu (clear security) everything ...

i have a big hunch that it may have something to do with my laptop...but anyway... when id datalog, it wont last longer than 30 seconds before freezing... im scared it might cause something wrong with my ECU... everything else works besides recording a datalog.
oh BTW...it only freezes when im ...

It is necessary to connect the ELD SENSOR in the converssion harness?

Plug E pin9 what voltage should reach that pin?

I Probe the ECU in another vehicle and works well, probe 3 ECUs and the problem still follows

As long as I do not accelerate everything works fine.
When you accelerate the laptop loses connection with the kpro.

This happens to me connected to the laptop but not when I record datalog