Hondata

Hi

I just done a search on this and i found a thread in the k-pro section saying that the s300 has anti lag. Is this refurring to launch control or real anti lag?

thanks
Yasir

cold boost cut is set at 30psi however the car only runs 10psi. The reason why the owner wants to over come this problems is because his engine temp goes all the way to cold when hes highway driving. Could this possibly be because he doesnt have a thermostat?

Hi everyone,

What would help maniplulating the s300 to help prevent the boost cutting?

Thanks
Yasir

Orite well my dad socketed the ecu, when we 1st started to crank the car abit of smoke came from near the ecu. but then after that ive driven the car a few times and tried to map it.

So ill have to get my dad to take the s300 stuff out and put it another ecu? will a po8 be fine?, i noticed ...

Yep, ive been trying to lean the maps out but it dont seem to be doing anything. However just today i connected up a po8 i had lying around and it was idling nicely at 14.5-14.8. Also ive blown the ecu fuse 2 times. So could this be something blown in the ecu or faulty s300?

Yep,

stock b16 with turbo kit and hondata s300.

Yep 240/240 in fuel trim and ECT compensation is in the middle

Hi guys,

My friend has had some issues with fueling for his car, i dont think its to do with the s300 though.

Everything has been put back to stock apart from it has a turbo kit and s300 running stock B16 map.

The problem is it just runs rich all the time, at idle it runs 10.1 AFR's.

Any ...

Found the problem, i thought i had orderd low impedence injectors but they were normal saturated ones. So i was using resistor box for no reason.

About the wastegate, it seems to be running 8psi quite nicely. Leaving the top port to atmosphere, would this not cause over boost?

Hi everyone

Ive just managed to get the car running, idles quite nice. Now the problem is it seems to be very lean @ WOT and when you start to come on to boost and its making no power at 10psi. Ive been increasing fuel shit loads and it dont seem to be making a diffrence. Could this be because im ...

sorry to wate everyones time, its now running

Hi everyone,

Im finding it quite hard to get my engine up and running with these injectors. It took me around a hour to get 750s working on my mates b18. So i was wondering if anyone here has a map i can get the car started with. Also i have stock map sensor and fpr.

Thanks
Yasir

Is motec 3bar setting ok for gm 3bar?

What would be the correct way to wire this in?

Thanks for your help m8 8)