Hondata

I know a warning about this was displayed but what can I do to make it work? A window pops up everytime I try to open SManager that says: Cannot open, file is corrupt.

the problem has been found. it seems like the tune just flew out of the ecu. i got the tuner to put the tune back in and the car started up and purred like a kitten, like always. this should be a sticky or a new faq or something. i don't know if this happens frequently or if it was a freak thing.

resolder the whole ecu circuit board?

so with the socket plugged, put one lead of the multimeter on a pin on the socket, and the other lead on the opposite side of the board to the corresponding pin? is it easy to see corresponding pins from the socket to the underside of the board?

thanks for the responses

what specifically should I be looking for in the socket? when the socket is removed, does the calibration have to be uploaded again?

thanks

I went racing on labor day and the car ran perfect. No problems with the motor or anything else. About 3 weeks later I install a new tach, change the oil and change the plugs. When I try to start the car, it starts and runs like shit, almost like its misfiring. I pulled the plugs and they were ...

its all good my car just made 505 hp losing traction on the dyno @ 16 psi

there's no turning back to the stock map now with the installation of the SVE 3 bar.

the map sensor says it should read 1.65V @ atm pres. so i did some hardcore math and found the scalar and offset to be 881 and -440 respectively, which netted me a 1.651V@atm pres. i uploaded this to my ecu and the motor didn't like it. so i went back to the motec 3 bar which is 1.66V@atm pressure ...

i'm pretty damn sure i have the 3 bar SVE map sensor wired correctly. is there something i need to change? i changed my map to custom and the voltage parameter looks about right. is there any other map parameter that i need to change?

sweet thanks

How do I retrieve a baseline for the initial startup of my H22 turbo? Do you have a file i can download or do i need to input all parameters on my own?