Hondata

all stage 2 cars are like this. you need to use the lil red button to set vtec and such

I cant figure out how i am going to get my wideband to go into the harness on this car. I have the plug wired up for 92+ cars. now im stumped. please help

that sensor from honda isnt cheap lol...

still a good deal though

well here is what i did. I got the idle as good as i could get it in open loop. I switched to closed loop and the idle is like 14.5 or so and is much better. i havent touched any timing maps what so ever and my tps is at .46 at idle. In most cases can you get the car to idle perfect while still in ...

Hey guys. Im pretty new to tuning and i have a 2000 si. I have loaded the base maps but for some reason the idle wont stand still. It will bounce sometimes. sometimes be good. Its weird. I have an FJO and it is around 13.0 at idle. Usually what do most cars with stock injectors idle at? Thanks for ...

right i know its in limp home mode....my question is why!

ok new stuff.

got a new ecu to start with. auto p28. I removed rp 17 and rp 18 and installed a jumper across rp18. Install the rest of the hondata stuff:

28 pin socket
y4hc373
j1 jumper
r54 resistor

i burned a rom for my car (00 si, stock b16 map) and the car starts and has a solid code. I try to ...

it depends alot on your timing as well as the boost levels.

ok i got the datalogging issue worked out. I also finally got my wideband all setup so i can move it from car to car and no codes or wiring. Beautiful.

I have a question though....I told a friend to grab the rom emulator socket chip (the taller pointier one) and he broke it. Do need a special one ...

Hey guys. I got my s200 and have been plagues with bad luck since trying the install. My first ecu i had was bad from the start (not hondatas fault), The 2nd had a previous chip and during the removal the ecu got messed up (not hondatas fault again).

Enter today.

My friend had an ecu that was ...

well i now KNOW that my ecu was faulty and could have been the problem..I will find out later when i solder in the chip into a new ecu.....Thanks for the reply man. Much appreciated

hey guys...i just got my s200 and am installing everything. The hondalogger will not connect to my pc. When i first tried to connect to my pc it said connecting...then 2-3 seconds later it was followed by a error no connection made screen.

so i tried to disable the fifo buffer...this time it said ...

Hey guys...i just got my s200 with basically every option and am installing it into my p28. Have a question though. The capacitors and resistors. Which ones are needed or not needed for a p28? I called hondata and spoke to a tech and he said that some arent needed. Just curious. Also, if i lose a ...