Hondata

Just for reference for future readers of this thread the problem was a faulty s300 board.
Managed to deal a replacement with hondata.

RMA 6001

Hello
Does anyone know if there is any problem with hondata rma procedure or support cause of covid etc ?
I sent my ecu and the s300 v3 board for rma and while i discuss via email for the return shipping then no answer 12 days after the last message.
Does anyone know what is going on or if this is ...

It would be amazing to have nitrous progressive control.

Ok i send the mail to support and waiting for further instructions.
An other video showing the problem.
https://youtu.be/sT5ZcRyoVl0

Yes of course J12 is cut.
I tested the faulty s300 board on an other ecu P30 which i am using a known good s300 v3 board and it does not work also.

I tested also the known good s300 v3 board on the other ecu and it works fine as it should.
Ecu with new capacitors.
The faulty s300 board shown online ...

Hello guys.
I experience a problem with one of my s300 boards.

Serial number = 46200
Software version =2.7.5
Firmware =10
Calibration is for test a new p30 usdm file uploaded after i erased .
Vehicle is edm civic eg6 sir with the stock b16.
Using two ecu a p28 and a P30 both with new replaced ...

I would like to have on nitrous aux a function with ECT minimum and maximum condition.
I want this for using nitrous aux output as generic output for powering electric water pump by ECT temp.
Also i would like to have the security antitheft functions same as the S-manager have.

Am i the only one who would like a black backround for the datalog graphs ?
Is this hard ?

If i choose to disable nitrous at check engine light will it close also when shift light is on ??
Or shift light use other code not affected by check engine light ??
I searched parameters help session but no info found.

Then you think that this is acceptable and not a malfunction ?

calibration attached.

Hello
I tuned my car with S300 V3
My setup is nitrous dry with S300 manage the fuel from 425cc injectors .
While i did some pulls to fine tune the nitrous AFR i found at a datalog that nitrous in ON when i close the throttle to shift to next gear.
My TPS minimum for nitrous ON is 98% while this is ...

Here is a video showing the issue.
I opened a log file to read and tune.
Then i close all log files and when i try to datalog again to continue the tune then the issue is happening.
Most of the times it starts to datalog instantly.
But 3 out of 10 it happens what the video showing.

https://youtu.be ...