Search found 7 matches
- Wed May 12, 2021 10:23 am
- Forum: s300 / SManager
- Topic: Ignition Cut Randomly
- Replies: 2
- Views: 1186
Re: Ignition Cut Randomly
Will do, thanks!
- Tue May 11, 2021 8:18 pm
- Forum: s300 / SManager
- Topic: Ignition Cut Randomly
- Replies: 2
- Views: 1186
Ignition Cut Randomly
Run into an issue where I'll be 1/4 or WOT and it just cuts for no reason. I've looked at my data logs and it seems to be the speed sensor dropping out causing the cut, however I changed the the speedo sensor with another known good one and still have the same issues. I've also tried turning off ...
- Fri May 29, 2020 11:03 am
- Forum: s300 / SManager
- Topic: ELD d10 not working! can only use d14 primary o2 sensor
- Replies: 20
- Views: 15645
Re: ELD d10 not working! can only use d14 primary o2 sensor
And if that bad boy is bad can it cause my crank no start issue?
- Fri May 29, 2020 9:57 am
- Forum: s300 / SManager
- Topic: ELD d10 not working! can only use d14 primary o2 sensor
- Replies: 20
- Views: 15645
Re: ELD d10 not working! can only use d14 primary o2 sensor
Bringing this one back from the dead!!! That brass piece was loose on my ECU too and I was wondering if that was causing my crank/no start issue and also my running like crap issue. I put a screw back in there but care still wont start!!!!!!!
- Thu May 28, 2020 7:36 pm
- Forum: s300 / SManager
- Topic: 'distributor error' sensor?
- Replies: 10
- Views: 8385
Re: 'distributor error' sensor?
Thanks for advice! I did try multiple distributors with no avail. I also tried swapping back to the stock ecu and still didn’t start!🤦🏼♂️
- Thu May 28, 2020 4:08 pm
- Forum: s300 / SManager
- Topic: 'distributor error' sensor?
- Replies: 10
- Views: 8385
Re: 'distributor error' sensor?
Soooooooooo, anybody got any ideas?
- Thu May 28, 2020 8:45 am
- Forum: s300 / SManager
- Topic: 'distributor error' sensor?
- Replies: 10
- Views: 8385
Re: 'distributor error' sensor?
Noticed this guy was on in the sensor list and my car wont start now. It was driving fine, went for a spin, would die in between shifts and at stop light, then really hard to start afterwards. Got it home and now it wont start at all. I have spark and fuel pressure at the rail, I haven't checked ...