Hondata

found it, thank you 🙏

i can do that with my infotainment (factory screen) but couldn’t find ethanol on the iphone app

Hi members, can someone guide me how I can display ethanol content on my Honata app on iphone? or it’s only possible to display that specific data on the infotainment system. I would like to remove my honda-heck if possible because it slows down my infotainment quite a bit.

or is it possible that ...

following. i have compared my oil temp readings from my zadatech oil temp gauge and log R on my FK8, the difference is under 3 degree F, over range from 90ish to 135ish. hope Hondata could figure it out soon.

Any update on this? So do we have an oil temp/pressure sensor on 2020+ FK8?

Updated firmware 3.6.1 yesterday. Confirm rad fan is not on anymore even with 3.5% ethanol on the same map and options. Thanks for the fix.

Currently using 3.5.8, does the beta 3.6.1 fix the rad fan issue?

Latest non-beta version I am using.

And I tried following this last week, same issue.

Most importantly, I am getting my car dyno tuned. If the fixed is released after, can I have the fix applied to the tuned map? Or do I have to copy all the tables manually to a new base map?

Correct, I have tried many different setting with the latest “non-beta” version, followed all the directions from Aston on FK8 review group but still no luck. The rad fan turns on full speed when Ethanol is lower then ~5%, and most high octane pump gas here in Canada is under 5% ethanol... so it’s ...

Mine is 2019 Canadian Version

FlexFuel01.fpcal

Here is the calibration. before i tried 3.5.9 beta, I put ~10L of E85 in the car for the first time to make sure its reading properly (not easy to get E85 where I live so took me a month to finally got some) I drove the car around the block to mix the fuel and it showed ~16 ...

Tired for 2 weeks, still no luck. How can I upload my calibration so you pros can check for me? I will download the lastest beta 3.5.9 and try again.

I tired 91 oct DP intercooler improved throttle response map with all 3 ethanol options checked, 2nd O2 disable checked, Reb hang and 7200 rev limit Checked, and I tried E0-E80 map with only ethanol input thru ECT2 enable, other 2 ethanol options not checked, the rest options same as above. Both map ...

Those temp settings are default from the 91oct map, I didn’t change anything and it’s showing weird unit but I think it in F. Problem is the fan starts right the way even the water temp and oil temp is at 20C.