Hondata

Build 2772

Version 3.9.7.0

Many thanks to the Hondata Support Team.
My issue is resolved.
Thanks again.

Cool thanks. will do.

Thanks Hondata for replying back. The check marks are all green. I tried to upload a new calibration this morning. The upload starts because I see a green hour glass on the bottom left next to where it says FlashPro, but the upload stops and I receive the same error message.

-Serial # FP-SI-US-232601
-Hondata FlashPro Manager 3.5.8.0
-Calibration FG2/FA5, MAP based, Injen CAI, race header, highflo cat, stock catback. I will attach the calib once I'm on a PC. I'm using a Mac.
-no datalog available
-2007 Honda Civic Si Sedan
-Stock ECU
-CAI, race header, and j35 throttle ...

I was in the middle of upload a new calibration and I idiotically turned the car off. Now, I can't upload and receive this
-The last FlashPro upload failed.
Failure information : Code 0x00 Setup 10 Address
0x000000
Explanation: Engine is running or bad contact from the WEN pin in OBDII connector ...