Hondata

Hurray!
I finally have AFR in my datalogs. Managed to smooth the cruising AFRs but its pretty erratic on otherwise.

I shall take a datalog tomorrow and post it here.


Thanks.

With this external wideband selected, the AFR readings start flowing to Kpro and my datalogs. This would mean I'm running in closed loop at all times? Problem is, I'm running a custom tune(open loop) & I'd like the ECU to operate by looking up the custom tables made by my tuner.

Apologies in case I’m causing confusions with my posts but I’m pretty frustrated with watching my AFRs on gauge and not having them flow to Kpro and hence my datalogs.

As an alternate, I read about Closed loop to Open loop switch based upon engine load. What should be a safe engine load figure? I ...

In analog inputs, I have selected Aem Wideband. Afterwards, in closed loop parameters window when I select External Wideband the car would go in closed loop. Right?

Right now I’m relying on the gauge that was supplied with aem wideband to keep AFRs in check but on WOT i gotta focus on the road instead of the gauge

You need to select the external wideband and then select the input you are using for the wideband.


Won’t that make the ecu go in closed loop? Correct me if I’m wrong.
I want to stay in open loop as I’m custom tuned. Just want the AFR readings to flow to kpro from my aem wideband and hence ...

Spunkster wrote: Sun Apr 05, 2020 10:45 pm Post your calibration as well as a datalog showing the issue.

My calibration is attached. The problem is I can't figure out how to enable wideband readings to flow to KPro(and hence my datalogs) while staying in open loop. What option should I select here(refer to the picture please)

Car starts going lean when I select External wideband in Closed Loop parameter tab. I just want want A/F communication between my wideband and Kpro while staying in Open Loop so that I can start taking logs with A/F info and make adjustments to fuel. Right now A/F is visually available from the AEM ...

Reverted to 4.4.2 and it sorted the problem.

It is the same as the 30-0310. Thankfully after using 6 different analog voltage output schemes AEM decided they did not need a seventh.


Thanks for clarifying that. So I selected 30-0310 in Analog input 0. Is there a way I can continue operating in Open loop but still get A/F info in to K-Pro ...

CORRECTION: I downloaded the latest beta: 4.4.3.

Everything was running fine till I updated my K manager to latest version 4.3.3.
The first time i connected the kpro to laptop I got the pop up that K Pro firmware needs to be updated. I pressed OK but there’s no connection. Didn’t get any progress bar and the status shows offline.
Uninstalled the ...

Hello,
Struggling to find support for AEM 30-0300 wideband which I installed in my car. Want to connect this to Kpro so that datalogs can have A/F info. I connected the wideband to the analog inputs. Unfortunately, even the latest version of K-Manager doesn't show support for this particular model ...