Hondata

👍 appreciate the response

I'd like my kpro v4 (base rsx ecu) to be able to read fuel level. Obviously, it would need to go from the sending unit in the tank to the analog input on the board. What I don't know is the proper wiring or if any resistors etc are needed. I'd appreciate a guide to do this. Thanks.

Oh great! That will help a ton, appreciate the reply.

Can you share a diagram on how to setup the boost controller solenoid with an internal w/g setup? I have seen the external diagram but haven't seen one for an internal w/g.
Thanks.

Possible to get nitrous bottle pressure sensor into kpro? If so, is this the proper guide? https://www.hondata.com/help/smanager/i ... essure.htm (for kpro not s300 obviously)

Very well. I'll keep looking into it. Thanks

Back of the cluster has a cable that goes right into the transmission with a d series cable speed sensor. The d series cable sensor is a drop in for all k series transmissions. The only way to get the cluster speedo is to tap the b16 vss (yellow) from the link above to the a18 vss (white green).
I ...

Good question probably doesn't. B16 on the oem ef harness (speed sensor) from or to cluster gives a signal

https://www.nthefastlane.com/honda-obd0 ... cu-pinouts

Also stock cluster shows no speed also

K swapped ef (91 wagon) with crv trans (using oem cable vss) running base rsx (manual) wiring harness and a56 (base auto) kpro ecu v4. Depinned a18 white/green and ran to the internal kpro board on vss (red). Changed under misc to alternate speed input. Followed the exact guide here.

https://www ...