Hondata

A make shift/in the process of trying to get data to complete in future from Derek Robinson called "Rampage Rev.01" for a turbo swap from Rampage Fab. RS-450

HPFP* Is probably High pressure Fuel pump right?

Ok, thanks...How ever I should have you know that I was ABLE TO MARRY THE ECU With the FLASHPRO BUT there was an error during, at start of, flashing which was "HFPF Not enabled on flashpro". THoughts?

From the picture attached, you can see I can't seem to attach my FlashPRO with my ECU.
Yes - My ECU is new.
Yes - I have successfully applied Jail break

My question is, do you guys already have this file or do I need to send it, as I didn't want to sit in my car for over 120 minutes, as it ...

Thanks for that -_-! I was under the impression I was going to have to find Marty McCfly and the doc and get those guys to help me with the update if you told me otherwise.... Thanks again!

Is this normal? (Normal Being in the sense that the software is searching for updates but there is no network connection and so it causes it to do what is shown?)

OK. Well It seems to want to boost at first attempt WOT, however the next attempt seems to be like it is stuck open or as the boost drops significantly to 4-5 PSI until you turn the car off and let the cycle of the waste gate return to the off position. I just want to know how to get it back to ...

Ok, and so I guess that doesn't really state what I am looking for as an answer so I guess maybe I asked the question incorrectly. What I am (Thinking) I would like to know is if there is any way to get to that "Stock" spec of "linear travel", could that be done using flashpro with some sort of ...

I apologize.

So the issue has been narrowed down to a possible failure with the waster gate actuator on a drop-in upgrade turbo setup (Manufacturer specs - https://www.rampagefab.com/product-page/rs-450-oem-turbo-upgrade-fk8-civic-type-r) recently added. Reason being the turbo builds boost be it ...

I was wondering if anyone knows the Idle and Command (mm) specs of the FK8's stock actuator settings? If not would anyone mind running a data log
showing the following items at the requested states - WGCMD & WG

1. Idle
2. Command
3. Cycle test of key On engine off

Any help is GREATLY appreciated ...

Sensor Edit

Also ALL sensor in question (See Attached) Have been replaced with OEM Genuine HONDA sensors.

1. 18 Civic Type R / 37820-TGH-A01
2.FP-CTR-FK8-351393
3. Yes
4. I(I am Running on a current revised "Trouble Shooting" Purposes Cali.
5. Data Log WAS attached last post

So, Here is a data log after nearly 2 months of what I will refer to as my "Honda Aids" issue aka P0106. It finally removed it self after countless hours today of trouble shooting. Sadly, as seen in the attached items 1. A datalog in flashpro showing the turbo limp status still ongoing, along with ...

So, first and foremost thanks for any help that may be given prior to...(It has [and although narrowing, still is] been a sort of hell-looped-NIGHTMARE)
The link below is referenced to a forum topic (obviously) to an on-going issue aka CEL P0106.

https://www.hondata.com/forum/viewtopic.php?f=51&t ...