Hondata

Spunkster wrote: Fri Feb 28, 2020 12:41 pm I would recommend the you try this ECU on a different vehicle using their calibration and see if it has a similar issue.

I'm gonna try another ecu with my calibration. If I don't get this weird rev limiter issue, then I know for sure that it's my ecu...

Spunkster wrote: Thu Feb 27, 2020 12:29 pm Try creating a new calibration from the new calibration menu and see if you still have these rev limits. It appears you may have a corrupt calibration.

Here you go...Same issue with a fresh new calibration.

Spunkster wrote: Thu Feb 27, 2020 12:29 pm Try creating a new calibration from the new calibration menu and see if you still have these rev limits. It appears you may have a corrupt calibration.

Ok, will do and report back!

Spunkster wrote: Wed Feb 26, 2020 11:59 am Try going to the online menu and erase the ECU, then key off when it is finished, close the program and reopen it and reupload the calibration.

Here you go...

Spunkster wrote: Wed Feb 26, 2020 11:59 am Try going to the online menu and erase the ECU, then key off when it is finished, close the program and reopen it and reupload the calibration.

Will do!

Spunkster wrote: Tue Feb 25, 2020 10:37 am Post a datalog with that disabled and post the calibration used for that datalog.

Sure thing. Here you go...

Spunkster wrote: Mon Feb 24, 2020 11:57 am Have you tried disabling the lean protection?

Yes, we have...It's definitely not hitting a lean cut.

Highly unlikely, as posted above spark plugs are ngk bkr8eix gapped down to .018 brand new. When getting cut, boost is around 15 - 20psi... The rev limiter activates at weird rpms besides 1st gear it, it will let me go up to the rev limit which is at 9400rpms... Car drives perfectly fine when not in ...

So I did a sensor overlay log on the rev limiter active overlay and it shows the sensor activating and deactivating at different rpms besides the actual rev limiter which is at 9400rpm. My question is if this is normal? I thought the rev limiter would only activate at the actual rev limit that it is ...

Hello, I have weird rev limiter issue going on with the v4 version 4.4.2.0...
My upgrade was done with you guys which is from kpro sn # 3219
ecu sn # is 2062-100437 pnd-a01
kpro4 sn #48768

Anyways my issue is that I will hit limiter which is set at 9400rpm in 1st gear but in 2nd gear it will cut ...