Hondata

This is too all people that may be intereseted in K-tuned 'Hall Effect' TPS Sensor. I have had (2) of there K-tuned Sensors and they do not operate as designed. They are having issues with there sensor (Hall Effect) , maybe recently. Unfortunately, they will not relay that message to you. I have ...

I will do that thankyou.


Also, I just figured it out. I put my stock TPS sensor and ran as it should no problems. k-pro recognizes TPS valuation during engine on and driven. Just spoke with Ry-wire....K-tuned 'Hall Effect TPS' outside wire Power and Ground do not match Ry-wire TPS connector via ...

Please help anyone? I recieved my second K-tuned 'Hall Effect TPS' and I' am getting the same results. RPM cuts out at 2500 RPM . Checked A-15 pin and gettng the 5V signal. Getting good signal, voltage and ground from the sensor 3 lead wires. Calibrated per required closed and open voltage, then ...

A-15 voltage is 3.75v. Again, same results during engine run. Removed ecu-A plug to check. Anything else I can do?

A-15 TPS signal ECU for 5V?

I just replaced my new K-tuned 'Hall Effect TPS sensor with a current new one and Iam getting the same results for my build. With key on engine off, 'Sensor' tab shows accurate 0 to 100% variation with pedal movement. However, with engine running 'Sensor' tab does not recognize TPS variation and ...