Hondata

Any other ideas to troubleshoot? I'm stumped here..

Same result. No sensor detected on digi input.

I will check it when I get home from work. Question though why would that affect it? Flex sensor has been installed since I got the kpro and is functioning properly.

Absolutely nothing. Parked it working fine. Sat for a few days then my current predicament happened.

Unfortunately no..

Yes. Tried a few known good calibrations

Nothing changed. Just battery was low voltage and it struggled to start. Started on the 2nd try and boom no sensor detected. Ethanol content has been setup for a long time

Sorry digital connection looks wrong in the first photo. Here is a better look with it disconnected. Again shotty wiring is temp.

Please forgive the shotty wiring, this is only temporary until I find the problem. Last photo is the placement of the old PLX.

Update: Brand new PLX installed. Analog working Digital still not working to KPRO.... No Sensor Detected

Just ordered a new plx complete. Will update after install

I forgot to say the analog input is reading signal but not displaying A/F . When hooked up digital the Digital 0 read a flat 10.0 as well as the A/F. With Analog connected A/F sits at 14.70. Does nothing with throttle change. Analog 0 reads around 13.90 at idle and has changes with throttle.

Connected to analog. Changed parameters to configure analog. Analog is reading signal but not nearly as good as the digital used to before this issue.

The only thing I can think of is it's the KPro board. Like I said the wideband reads fine on it's own. All wiring is the same and w as s working for over 6 months. The car runs fine. Kpro can still make adjustments to fuel maps parameters etc. I think something is wrong with the digital input. Any ...

Waiting for PLX devices to look over the test data of their controller and get back to me. From what I see it seems to function properly. Here's the test instructions they sent as well as the results.

Instructions:
Ok. There are some tests we can do.
First have the SM-AFR get power direct off ...