Hondata

Thanks!
Seems like it start working properly. I dont know exactly what helps. Steps:
1. Completely delete previous version of the FPManager (4.1.1.0)
2. Download and install the latest version (4.1.2.0)
3. Download and install USB drivers from Hondata website
4. In PC settings i remove the FlashPro ...

FP-SI-INT-21823

Thanks for the reply! Exactly the same thing happens on 4.1.2.0. Hondata flashing with green light. FPManager is not responding after pressing "Firmware upgrade" -> "Ok". Still no green bar of updating the firmware

Hello!
Today faced an issue with the Hondata: plugged it to the PC, FPManager shows a message "The FlashPro firwmare will be upgraded. Please unplug the FlashPro from the vehicle" - at moment Hondata was already unplugged from the car. After pressing "Ok" the FPManager freezes and not responding (no ...

Strange enough. My friend also have 2 cable on his FN2, same overall look of the sensor/cables/pins as on mine car. He also uses Hondata calibration and launch works fine.
What would you recommend to check?

Hi Spunkster! Glad to hear from you!
I have already tested it... Some hours ago was testing.
Cruise control button pressed, clutch fully pressed in. Buttons resume and set has no effect at all. By pressing them nothing happens.
I suppose the issue is in missing cable to pin 1 on the clutch sensor ...

Good day!
Today i was playing with the clutch sensor. Find something unusual...
1. Sensor itself has 3 pins on it - i check them, pins 2+3 are energized if the sensor rod is slightly "extended" (cruise control)
2. Pins 1+2 (or 3) are energized if the sensor rod is completely extended (launch mode ...

Understood, i will try to check clutch switch on saturday and come back to the topic.
Thanking you so much Spunkster for your feedback!

And im so sorry for stupid question - how do you check the clutch switch position in the datalogs?
I tried to use Graph - Clutch Position, but the graph is empty...
It will help me to understand the switch working or not after dismantling/changing or so.

Hm... But before reflashing the launch rev limiter was working even without clutch pressed. It was malfunctioning?

Good day, Sir!
As you told me, i make a few datalogs trying to get launch. Engine is reving freely, without any stops or limits. Logs attached.
Hope it will help!

Understood, i wasn't using the old one, just check what did the CD contains. The calibration i re-flashed was made in the latest FPManager. During last 2 days i reflashed the ECU several times with different launch rpm starting from 3500 and finishing with 5000 rpm and different disengage speed from ...

Hello!
Recently i have bought a used Hondata and tried to reflash the ECU with GroupN calibration.
ECU is stock Euro FN2. GroupN calibration was slightly modified: VTEC to 4400 rpm and launch to 3700 rpm.
Everything reflashed fine, the VTEC is 4400 now, red line became higher - 8600, but the launch ...