Hondata

Thank you for the advice; good luck out there.

Turning off Fuel and Oil protection seems to have solved the problem. I just did a log and could not replicate the issue. Is there anything else I should change with protection?

Sorry it took a while...
I was able to capture two logs with the RPM cutout.

At the end of S2000SoSStageII38pulley nolc 071625 01
and in the middle of S2000SoSStageII38pulley nolc 071625 02

I turned off launch control for the run. The issue only pops up after the car is fully warmed up.

Will do, I'm away on business for the next 5 days. I will post the logs and config as soon as I am back.

No, disabling launch control didn't not stop the behavior. I tried 4 runs with it off. I'm still getting that random high rpm cutout.

I think I caught it in these two logs. At the end of the first and in the middle of the second data log. Also attached are my tc map and kpro map.

Yes I have a Hondata Traction Control is also installed.

I have an issue with my 2003 S2000 running Kpro v4 Serial number 40523.

The car has been randomly hitting a rev limit/power cut above ~6000-7000 rpm, especially when the car is fully up to temp or hot from a drive. I've checked everything I can think of including the spark plugs, plug gap, coils ...

Can you add the option to flash the abs light or a similar light on the dash when your hondata traction control unit senses slip and activates?

That's too bad. Thank you for all the advice. I will finish up everything when I have a moment away from work this weekend.

Thank you I believe I have I believe I found the right wire. First harness, directly connected to the ECU, closest to the hood release latch. I also have to switch my O2 sensor from the one connected to the ELD over to the wide-band connected to my Analog 0. I believe I have covered now in my ...

Anyone have a picture of the harness that I need to tap A30 on? I just want to make sure I am getting to the right harness. I have a Kpro v4 with serial number 40523 and traction control serial number 12586. I have every other wire connected and ready to go except I am not sure exactly what harness ...