Hondata

datalog and calibration from today Thanks

What is the arrangement you are working with?
ie: intake, exhaust, etc.

Thanks for the support.
Go to the options menu and make sure that tables follow vtec and tables follow cam angle are both checked.
Yes both those options were/are checked - still no access to those lambda overlay tables.
I did down load a calibration from a similar project for reference - Insight ...

No, not JDM
I'm curious where you're going with this...
What bugs you about it?
I was concerned about the almost constant +13 STFT, the .63 v,
I did use propane on the intake and immediately the stft went to -18.
what I don't know is fi it's biased.
Havent found anything online about volt-amp output ...

stock rsx base sensor
been reading about what is considered proper voltages for one
you probably noticed the .63 volts it seems to favor.
Right now trying to understand that.

The calibration Thanks

Thanks for the reply. I found that I needed to click the tab for 20deg cam before I'd see any values.
Didn't see much change in stft after adding 10% to those cells.
But I'm also not seeing leaner than 14.5:1 fuel being commanded. I'm trying to lean this thing out a bit but getting little response ...

Thanks for the quick reply,
Not sure I understand what you said, and need clarification:
Go to Options, Settings and then go to the Lambda Overlay tab and make sure that the values there are being met. If it still does not show the values then you may need to restart your computer.
Are you saying ...

Hello,
2002 Insight
JDM K20A3
04 Accord Trans w/3.4:1 FD
I've successfully loaded k manager, set up many options relevant to my setup. Car seems to run really good. I have ran a couple of datalogs. The pics are from one of the datalogs.
I’m not tuning for WOT performance. I am looking to make MPG on ...