Hondata

Wondering if there's a place where I can get the definitions of the sensors listed on the Graph template when creating a new template. I created a new template but would be nice to know what I"m graphing.
For the time being is the below correct?
DUTY = injector duty cycle
INJ = injector open time ...

Thanks Spunkster. Changed the color and I'm alble to see now, that aqua color was terrible.

How do I change the font color on the graph tab. On datalog graph "default" drop down it's hard to see the MAP graph, where can I change its color for this "default" down down?

Regards

Is there a way to test the outputs on Kmanager? Like how the s300 can.

This is a K swap Toyota MR2.. the wire w/tape goes to boost control solenoid.. the other wire at boost control solenoid (red paint on it) goes to +12volts ignition with 5amp fuse.

It's the wire with blue tape on it... do I have it in the right pin? The original wire that was there was a different color, I depinned and put that wire in its place.

I have a prb-A03 ecu, and using pin b21.. I'm assuming that link references the same ecu?

Kpro V4/Kmanager help needed. So I have an issue where the ecu will throw a P0113 IAT code when I plug in the boost control solenoid (MAC 4port 46A-AA1-JDBA-1BA). I have 1 wire to +12 ignition and other wire to B21 (B plug, pin 21) of ECU. I verified there's no short in the wiring as well. This ...

ahhh, gotcha... I didn't see it cause it opened as untitled and didn't even think of opening the tabs. Check the tables/parameter and there is a tune there. Clicked save as and all is well. Thanks for turning on the light for me!

it's a .kal file. I was just searching for a base tune for a stock k24a2 turbo that I could use.

Also, the Kmanager isn't connected to the ECU. Not sure if I need to be connected or not.

Just wondering if we are able to download files that has been searched for in the vault. I double clicked the file to download, which isn't mines, but can't find the file anywhere. Does it save it to a specific location? or can you only download files you have uploaded?

Thanks

So I have a weird issue, My Kmanager (version 4.4.2.0) w/Kpro V4 will show "ignition on" and "online" once I plug the USB cable in even when the ignition is off and key out. I have no problems starting the car. Previously it would say "ignition off" until I turn on the ignition. I tried to load a ...

Thanks

So I have a k24a2 swap MR2 using Kpro V4. I have the 1 wire trigger from the chassis that I could trigger the AC compressor but that bypasses the ECU and thus doesn't idle up when AC is running. I see the Kpro V4 has an alternate AC trigger input but it uses the VTP for AC input. Question is, don't ...