Hondata

disconnected everything, brought it over to the bench, hooked the USB up and still not connecting. KManager still shows offline

I just pulled 4.4.9.0 and loaded it. Still not connecting to the ECU. Drivers installed (confirmed in lower left), tried multiple USB cables.

wiring is correct - engine starts and runs. the piece that is weird is that the USB will not connect to the laptop.

Having an interesting issue again which seemed to have disappeared for a while.

Kpro4 S/N 43715
Kmanager 4.4.6.0

problems are this:
1) Green light is on, red transfer light is flashing - regardless of whether USB is connected or not
2) bluetooth is not found - can't connect Hondata app
3) USB ...

I’m not using any inputs to the kpro. I’m only using the can out to the dash.

serial number is 43715

software version 4.4.2.0
boot firmware version 2
main firmware version 14

outputting CAn to AIM MXS vserion 01.28.10 it's not an aim problem as even with the USB cable in Kmanager i get the same readings that the mxs is showing. still getting full readouts outs from the app ...

Lights in the kpro are all green. There is a red light at the usb when uploading Ecu program.

Kpro4 running kmanager 4.4.2.

With ignition on it shows the same 29.9 32 32 and No rpm readout in kmanager or on the dash.

All grounds are in place including the one on the cylinder head in the back as well as the secondary from the valve cover to the chassis.

Ap1 kpro mod with an aim mxs Data logger. Everything was working ok however after the last engine swap on the e production SCCA car I have some weird happenings.

1) map reads 29.9 on both kmanager and aim dash (can out)
2) ect reads 32degf on both kamanager and dash
3) iat reads 32degf in both ...