Hondata

Spunkster wrote: Fri Oct 08, 2021 9:41 am Using an auto ECU there will be no way to get the signal to the cluster. You will need a speed converter for the cluster to read correctly.

Oh ok, well Ktuned all-in-one speed inverter it is the way to go then.

Thank you.

The speedo will not get the correct speed as it is not output from the ECU.


So do i place the vss wire back into A18 and ignore the alternative speed setup to the VS on the kpro board?
what should my next move be?

The "alternative speed" setup does the same thing as the "countershaft speed ...

Ok, tried the counter shaft speed sensor this time and does the same thing.. but not as wildly

No, I'm using the "alternative speed input" and did the calibration 2485 smoothing 10... as instructed.

Hello guys,
I swapped a K-Frankenstein (k20z3 head/k24a2 block), attached to a 2007 civic si 6-speed trans( so countershaft driven speed sensor), into a 2000 civic hatch. Im using an 03 rsx auto PND ecu with kpro v4,
using a Phanetrics conversion harness

I have followed the speedo patch ...