Hondata

I'm still not having any luck with figuring this out unfortunately.
Anyone have any ideas?

Spunkster wrote: Tue May 21, 2019 9:02 am Please post a datalog of it connected even if you don't see anything.

Here you go.. Fingers are crossed for you finding something

Spunkster wrote: Mon May 20, 2019 9:53 am Post your calibration and a Datalog showing the issue.

Ive got the calibration but no datalog as there is literally no reading coming from A0

Really hoping its something simple ive missed as its stressing me out haha,
Thanks again

I've also done that and it is outputting correctly, I also put a multimeter on the actual red A0 wire and that's also receiving the correct voltage

I did do that yes, selected plx wideband and still no hope, then tried the custom function instead and scaled using lambda units and no hope.

I'll try and select raw voltage later and see if that picks up anything, if not I really don't understand what I'm doing wrong as it's literally 4 wires, one ...

Hello all, After searching the forum for a few days about this problem im still none the wiser.

Ive installed the plx which works fine but I can't seem to get the kpro to read anything from the gauge so I can just datalog/tune from it.

I've connected the supplied grey wire from the analog output ...