Hondata

Dear all,

I have the following issue with a FN2.
Top speed is 220 kmh which is very low for this model and i cannot figure it out yet why.@220kmh is at about 6800-7000 rpm and it will not rise any further no matter what. Rev limit is set at 8600 rpm.
Car has 4-2-1 headers, CAI rooted to fog light ...

Issue solved : I don't have a clear resolution for this but i went for a data log session and seems that this time it read correctly. The only thing that i have changed in the calibration was the Multiplexer from Normal to Disabled because the engine was swapped in a Del Sol. Don't know for sure if ...

Dear Spunkster,

Please check the 3 screenshots i have attached from "run1crxfrank.kdl" datalog file.
capture1 - see the values before vtec
capture2 - VTS is activating as the VTEC point is set at 4600 RPM.
capture3 - after crossover, VTS is on and table is switched to the highcam.Also, VTEC is ...

The setup it's a K24A3 bone stock block with K20A2 stock head with 4-2-1 header, 2.5 inch exhaust with one mid muffler and a cat-back, a 76mm intake pipe with pod filter.

Dear all,

I have this issue with reading the VTC in datalog.
The graph reads less that it was actually set in the cam angle tables.
For example right after VTEC in WOT, the VTC is set to 45 degrees but graph is showing only 22 degrees.

Any idea what it can cause this difference in values?

Thanks ...