Hondata

ich glaube wir reden aneinander vorbei.

nochmal kurz auf deutsch.

ich will weder früher noch später vtec, ich will auch nicht lastabhängig vtec. ich will bei den eingestellten 5700 rpm IMMER vtec, egal welche last anliegt. so wie es im original steuergerät auch ist. vtec soll NUR nach drehzahl ...

das dacht ich ja auch, aber das ist eben nicht so. ich hab jetzt beim low die vakuum werte vom high eingestellt und drosselklappenöffnung auf 10 %, die stand vorher auf 40 und der ist dann immer im teillast ausm vtec raus und erst ab 40 % wieder rein. wollte net selbst paar werte erfinden und rum ...

Hi,

I drive the stock P73 map on my Integra DC2. Loaded via SManager -> New

Can I change the Vtec point from 5700 rpm to e.g. 5000 rpm? I can do that for sure, question is if this stock map can handle fuel and ignition with this change. I see that in the vtec and non vtec map both values are ...

Usually you want the VTEC point to move higher with lighter engine load

I dont want to do so, how can I disable it? Please tell me.

The above screen shot shows VTEC switching at 5000 rpm when the manifold pressure is 5 inches vacuum or above (which is close to full throttle), reducing in a ...

good idea.


what does the pressure next to upper and lower mean? this value is still different, I didnt change it.

Hello,

I have a German Honda Integra DC2 with Hondata S300 V2. I loaded the stock map from the Smanager. In Germany you can drive as fast as you want on our highways and I recognized that Vtec seems to switch when driving around 6000-7000 rpm. When I lift the gas it sounds like it goes off, and ...

this one?

2001 Single Monitor (Knock Retard) - 52mm billet $89.00

why?
how can I use my knock sensor? dont want to do without? are there sensors with dc signal? can i convert it? can i use a aftermarket knock sensor? need it to tune ignition, dont i?

Use J&S Safegaurd - they have a knock retard signal 0-5v that can be input into Hondata.
THAT would be great ...

why?
how can I use my knock sensor? dont want to do without? are there sensors with dc signal? can i convert it? can i use a aftermarket knock sensor? need it to tune ignition, dont i?

Hello,

I have some experience with Hondata Kpro and Kmanager with my Civic Type-R 2005 K20A2. After my baby crashed I bought an Integra DC2. I own this car half a year now and just installed a S300 V2. With my Civic I could use my stock ECU and send it to modify and install Kpro. For the S300 its a ...

where can I get a 1.2.2.2 download?

a new version?

isnt it the newest?

tell me the link to the newer version...please.

i have win xp pro sp2 fully patched

KManager starts normal. When I want to open any map, or create a new one it always says

Access violation at adress ... in module kmanager.exe. Read of adress ...

here is the screenshot...

http://www.tralien.de/Verschiedenes/kmanager%20error.JPG

I cant load any map with this version ! Where ...