Hondata

All sorted now.

ECU Pin a2 did not have battery voltage (it only had 2 volts)

Sorted another wiring problem and uploaded and started the car fine.

-Chris

Another bit of information is when I initially was going to upload the new kal and when the firmware updated the battery voltage was low (so low the started would not do anything). If I remember correctly this may have been when kmanager was attempting to update firmware.

Today when I sorted the ...

- what vehicle you have
1991 Honda Civic with k20a2 & 6 speed trans with k20a3 engine harness
- serial number of your K-Pro
40327
- version of software being used (from Help, About)
Version 4.3.6.0
- ECU part number (starts with 37820) and serial number (the number under the part number)
37820-PNF ...