Hondata

Now if problem persists what could be? Bad soldering? Because all I have to do is unscrew a lily bit and move it works. Thank you

Ok .... you like to always say the problem is us, and grounds, ( I get that's the most common issue ) but in my case (after hours of work missed track times and calls to hondata, hondata forum and my seller tristate in NJ) I otnothing , finally talked to some one athondata( wish I knew his name so I ...

And also deleted air bag system ,and abs , inline fuel pump, and a lot of wires from inside, only tail light left


Could be inside the car the problem?

Yes under passenger headlight

All 3 grounds are new wires, the ground from the battery is a new cable, terminals are new, battery is new, and just tried a new starter and nothing, same problem.

Does it have to be on the ground side? Or could be on the positive? And any chance it could be on the kpro?

Any ground inside the ...

Ok.... so the lowest number I saw was 9v, and the light only comes on after about 10 seconds, my question is, can the problem be at the edu/kpro or not it has to be on the charge system? Thank you, there is no corrosion battery is brand new , and it's charging good

I tried today and it only happened once after that was fine and I could not get a reading, only when there was no light and it was 10, 11, and 12,
if It gets lower than 10, is it the alternator or starter?
Thanks for the help I'll try again tommorow...

What wires would I check?
And what voltage

Please some one help me, I have been getting this code for the past few months, since I got the car running...
Daughter board communication error ( low voltage at crank)

Does not happen all the times, but when it happens won't go away for about 20 times starting and turning off.
Brand new battery ...