Hondata

Spunkster wrote: Mon Apr 05, 2021 3:31 pm This is not possible as there is not a shifter position sensor.

Hi, how does the ECUTEK perform Auto Blip / rev Match? Same car just different tuning package?
This really is lacking for the Si and FN2 guys, would stop a lot swapping over to it if it was a feature of Flashpro

If you datalog with both USB's connected, what errors are there?


Hi Still getting the system error come up about 5-10 seconds after starting the car and being stationary. I can't find any fault codes.
I have also fitted a new battery, so know that's not the issue.

You say both USB connections ...

Thank you

I have some after market cams to fit which the suggested timing for the exhaust lobe center is 118 degree.
Can this be adjusted with Flashpro tuning or do I need to buy an adjustable cam gear to set it correctly?

thanks

Thanks, I’ll give it a go.

Hondata wrote: Fri Jul 30, 2021 6:56 am What vehicle? For most vehicles you cannot disable VSA without generating an error.

Euro FN2 2007
It was happening before disabling the VSA.

Thanks.

Bones126 wrote: Fri Jul 30, 2021 5:20 am Still have an issue with a "Check System" warning coming up on the dash.
I have disabled VSA & ELD. It appears to happen as soon as I move off.

Thank for any help.

There are no error/fault codes stored.

Still have an issue with a "Check System" warning coming up on the dash.
I have disabled VSA & ELD. It appears to happen as soon as I move off.

Thank for any help.

Hondata wrote: Sun Jul 25, 2021 3:17 pm Clear the errors with the software and see if they come back.

Thanks, cleared error codes and all OK now.
Possibly threw the errors up as it had been on the Dyno for tuning and back wheels not turning while the fronts were.

Thank you for you help.

Hondata wrote: Fri Jul 23, 2021 11:19 am Use the TC software and you will see any errors.

Hi, it’s saying the following

Error code 4 - LR WHEEL SIGNAL
Error code 5 - RR WHEEL SIGNAL.

thanks.

Thanks, will give it a go.

Hi,
I've fitted an second-hand traction control unit via the instructions on the site, but i can't find what the switch module led colour means. Mine is currently red which would suggest an error.
Could someone confirm please?

thanks

Thanks, to confirm on the Euro FN2 it is light green pin 23

@Hondata
@Spunkster

Can you confirm if the ELD on pin 23, should this be an orange wire too as my pin 23 is not ornage.

thanks

To share, it is.

Red/Yellow = RL - Red
Green/Blue = RR - Green
Green/Red = FL - Green
Pink/Green = FR - Pink