Hondata

Have anyone done dual 3 port boost control solenoid setup in kpro? By using NOS #1 to turn on the second solenoid. I was thinking running dual Mac 3 port solenoid inline with each other, when the one solenoid is at it''s max cycle duty the second will turn on and add more boost. Reason why I don't ...

Ok so I'm little confused here. Are you saying that E1 should not be connect to a relay(as a ground switch) to run a fuel pump?

Spunkster wrote: Wed May 16, 2018 12:55 pm They are showing readings. The conversion table you enter must be in BAR, then you can set the unit to PSI , then in the sensor window change them units for each input to psi as well with a reasonable min and max value.

WOW! change it to bar and it works. Thanks man.

Spunkster wrote: Tue May 08, 2018 10:30 am Can you post your calibration and datalog showing the issue?

so Spunkster, any ideas?

Ok here is my calibrations and datalogs that I did. Let me know if I miss anything else.

Anyone here know how to get kpro 4 analog input to read PSI instead Voltage? I change the unit to PSI or bar and it still show Voltage. Oil pressure and fuel pressure is what I'm trying to do.