Hondata

Ok. Spunkster can i give you my calibration and datalog? Maybe you can see if something is not correct in settings or something like that?

Thank you, great support!!

no, not tuned on dyno

Anyone can help me out with p0132 oxygen sensor high voltage? Wiring is correct but i get this error code in kpro :/ i have a datalog too...

hey spunkster, no i dont have. I dont know if its okay to disable it.

If it is okay i would disable it under "misc" right?

Today i have made a Datalog and i had another error Code P0132 Oxygen Sensor... First it was 1.4V and then after 5 mins. 4.1V. After that it felt down to 1.4V again...

i fixed the problem, it was a wire that was not located for the fuel pump.. now its okay!

I got one Error Code

P01298 ELD High Voltage. My question is, can i disable this on kmanager ? Is this okay or do i have problems with performance and so on?

I dont know why i have this error :(

Maybe ...

Hi spunkter , i will try it after my holidays.. Thanks for the fast reply.

Im very new in this kpro stuff and reading much about this. Should i clear security first? My problem is the steps to upload a map to start the car, i know that i have to be careful with the steps.

Can you or anybody else ...

It is cranking but dont fire up , cel goes on amd then after 2 seconds off. Kmanager say ign on and online, evu is connected and i can upload a map.

Maybe i did smth wrong when uploading and the car dkes not start.. I have unplug all the things before , maybe i have to upload a map and then the ...

Hello guys, i have a update!

Car was running last week, it was a wiring issue and my friend fixed it. Car and the fuel pump worked and started fine..

Last day i have put alle together and wanted to start and i didnt hear any fuel pump again.... But the CEL goes on and then off, all lights go on ...

thanks for your reply, but i do the wiring with a friend. I need to know two things guys, i have to figure this shit out...

1. Do you got a link / graphic for the pinout from the e connector ?

2. i got a problem with my C101 connector PIN 14. I dont get power from there to the ignition. But why ...

yes sir

i will double check thos things again, but i have one question. If Kmanager says that the drivers are installed and online, can i be sure that the ecu isnt damaged? Because the ecu was already tested for few days in a EP3 civic and all works fine...

Hello together! My name is Ares and im from Germany. I got a huge problem since last sommer 2017! My car wont start, here are the following Informations.

- what vehicle you have?
i got a Civic 2001 Hatchback ( EJ 9 with K20a2 swap )

- serial number of your K-Pro
My serial Number is 05009879 ...