Hondata

I was able to get it to work after trying a 4th usb cable. Odd the other cables work to upload and download log/cal files but would not work for the firmware update.

Hello,

With update to version 3.7.5 a firmware update was required. With the hondata plugged in and opening flashpro manager it says "The Flashpro firmware will be upgraded.". After I press ok the USB light on the flashpro turns off the power led blinks green and the flashpro manager stops ...

Also note full throttle shifting has been enabled since I first installed flashpro 2 months ago and only since had this issue in the last two weeks. I enabled determine WOT via map sensor 3 weeks ago and tuned the low cam but not the high cam yet.

I haven't had time to test this but I am thinking this is the issue. I did have my foot resting on the clutch, maybe its a bit sensitive? Is there anyway to monitor the clutch sensor in flashpro?

Hello,

I tried doing a pull tonight and the fuel cut out on my at 7300rpm. With the weather here being cold and the roads being icy I haven't had a chance to do many pulls in the high cam for a while though i believe this happened last week this same duty cycle and rpm. Looking at the datalog I ...

Thank you.

Ok this time I hit datalog as soon as I started the car and it seems to enter closed loop after 41seconds, correct? ECT is 4C and ambient is -4C. Seems much lower then expected.

I was under the impression the ECU should run in open loop until the o2 sensor gets up to temperature and I have heard that happens roughly when ECT is about 150F. During WOT strim drops to 0% so I assume this should happen anytime the ECU runs in open loop correct? Why is it when I start my car in ...